@Vermeijden wrote:
Hi all,
since some time now I'm running the latest version of PDF Creator, 3.2.2 and I have a problem with it. It occurs when printing multiple files at once.
If sending multiple files at once to PDF creator, it always 'stacked' the assignments. Then it was possible to merge these files into one document and save the files under one document. (This is very practial for an engineering company, where multiple drawing files need to be merged into one document all the time.)
The problem is that now it only shows the first two files - not more. If there are more files, PDF creator doesn't show these files. -> However, if then I continue to print these files, close PDF creator completely and open the program again via the explorer, the other, remaining files pop op. So somehow PDF creator saves these files in its memory, but doesn't show them on the first hand.
Anybody had the same issue, or a clue what is happening here?
Thank you for your reactions.
Posts: 1
Participants: 1